ES1JA
Пользователь

264 Спасибо

Страница 15 из 18 Первая ... 589101112131415161718 Последняя

• К странице:

1. 
   US5WE liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   Recommendation:set Bins/Pixel to 4 You have wasted lot of cpu resources on decoding to higher than 3kHz area. jtdx waterfall width determines decoding bandwidth. You will see Lag reducing. - - -...

   Liked On: 02.02.2022, 22:22

2. 
   RX3RZ liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   First part correct, only SNR affected, Sunsdr is like measuring device. Dynamic range does not change in general depending off ATT/Preamp, it just moving in scale. for sunsdr jtdx users: Set Preamp...

   Liked On: 01.02.2022, 12:15

3. 
   R6LCF liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   First part correct, only SNR affected, Sunsdr is like measuring device. Dynamic range does not change in general depending off ATT/Preamp, it just moving in scale. for sunsdr jtdx users: Set Preamp...

   Liked On: 01.02.2022, 12:07

4. 
   US4IRT liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   for this better set Tx in UI. 319167

   Liked On: 30.01.2022, 15:47

5. 
   US4IRT liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   Depends on Bins/Pixel value but in general 1 Hz.

   Liked On: 30.01.2022, 10:16

6. 
   RX3RZ liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   This happens only when Yo have changed Power ( Drive ) in esdr, In general all settings should be done only in JTDX. in JTDX power values are saved by band basis, when requested. So once power is set...

   Liked On: 14.01.2022, 09:42

7. 
   UR0HQ liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   No, TCI is there to stay in JTDX, Igor was meaning that when TCI is in use then Test Ptt in rig configuration can be been disabled, but not needed, I already found a solution for transmitting silence.

   Liked On: 02.01.2022, 22:01

8. 
   RJ7M liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   No, TCI is there to stay in JTDX, Igor was meaning that when TCI is in use then Test Ptt in rig configuration can be been disabled, but not needed, I already found a solution for transmitting silence.

   Liked On: 02.01.2022, 20:55

9. 
   R6LCF liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

   No, TCI is there to stay in JTDX, Igor was meaning that when TCI is in use then Test Ptt in rig configuration can be been disabled, but not needed, I already found a solution for transmitting silence.

   Liked On: 02.01.2022, 20:31

10. 
    UR0HQ liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    Bad choice, until +0.5 is OK, further Your tx will be worse for others. For just listening SWL mode can be used. From 158.. Early start of decoder option helps a lot in this area.

    Liked On: 30.12.2021, 18:40

11. 
    RX3DTN liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    when in QSO then tx message is ready immediate after decoding needed message ( not period decoding end ), this is long long time so.

    Liked On: 30.12.2021, 17:53

12. 
    RX3DTN liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    Bad choice, until +0.5 is OK, further Your tx will be worse for others. For just listening SWL mode can be used. From 158.. Early start of decoder option helps a lot in this area.

    Liked On: 30.12.2021, 16:32

13. 
    ER1CS liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    Stupid user with long callsign is calling with report. No way to understand.

    Liked On: 17.12.2021, 23:37

14. 
    UI6L liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    They are callsigns matched some "Wanted" entry.

    Liked On: 11.12.2021, 20:32

15. 
    UA3RMB liked post by ES1JA Вкл. thread : Проект WSJT-X: моды JT65,JT9,WSPR,JT4,JTMS,MSHV - работа с тестовым софтом - часть 2

    If You set waterfall (all settings there) as in my picture and in ESDR AGC :off and preamp to +10dB and bandwidth in JTDX waterfall should be same as in esdr (3.3 kHz in my setup) then it can be set...

    Liked On: 08.12.2021, 11:18

Страница 15 из 18 Первая ... 589101112131415161718 Последняя

• К странице: